10.34.2. Contents of E2fsprogs
Short Descriptions
Searches a device (usually a disk partition) for bad blocks | |
Changes the attributes of files on an | |
An error table compiler; it converts a table of error-code
names and messages into a C source file suitable for use with the
| |
A file system debugger; it can be used to examine and change
the state of an | |
Prints the super block and blocks group information for the file system present on a given device | |
Reports free space fragmentation information | |
Is used to check, and optionally repair | |
Is used to save critical | |
Prints the FS type of a given filesystem, given either a device name or label | |
Displays or changes the file system label on the | |
Replays an undo log for an ext2/ext3/ext4 filesystem | |
Reports on how badly fragmented a particular file might be | |
By default checks | |
By default checks | |
By default checks | |
By default checks | |
Saves the output of a command in a log file | |
Lists the attributes of files on a second extended file system | |
Converts a table of command names and help messages into a C
source file suitable for use with the | |
Creates an | |
By default creates | |
By default creates | |
By default creates | |
By default creates | |
Used to create a | |
Can be used to enlarge or shrink an | |
Adjusts tunable file system parameters on an | |
The common error display routine | |
Used by dumpe2fs, chattr, and lsattr | |
Contains routines to enable user-level programs to manipulate an
| |
Used by debugfs |